Poseidon Syringe Pump

Overview

This is a syringe pump created by the Pachterlab at CalTech. The project page is found here: Poseidon.

Obtaining Materials and Printing Parts

You can find the list of materials and vendors here.

Next, you must print the parts for the syringe pump apparatus.

The .stl files for the 3D printed parts can be found here.

Assembly of 3D-Printed Parts

The Pachter lab has created helpful videos on the construction of the pump apparatus once you have all the necessary materials and 3D printed parts.

Syringe Pump Assembly

Microscope Assembly (Optional)

Raspberry Pi Set-Up

If you are using a brand-new Raspberry Pi, you should see this page on set-up basics.

Once you have installed your Raspbian OS using NOOBS, you should connect to a Wi-Fi network. Then, open a terminal and run the following:

To update the Pi:

    sudo apt-get update

To upgrade the Pi:

    sudo apt-get upgrade

(If either of the above commands fails, then you have not connected to a Wi-Fi network yet... Do this and try again.)

To install a necessary GUI dependency:

    sudo apt-get install python3-pyqt5

To install a necessary library that will allow us to establish a serial connection between the Raspberry Pi and the Arduino:

    sudo pip3 install pyserial

We need to install a library called OpenCV, but first must get its dependencies by using the following commands:

    sudo apt-get install libatlas-base-dev

    sudo apt-get install libjasper-dev

    sudo apt-get install libqtgui4

    sudo apt-get install libqt4-qt3support

    sudo apt-get install libqt4-test

There is apparently some difficulty with loading OpenCV through the terminal... So we will put some extra steps into the process. We first must install an updated version of the Python Package Manager (pip) via the following:

    wget https://bootstrap.pypa.io/get-pip.py

    sudo python3 get-pip.py

Now officially getting OpenCV-Python is another series of steps:

    wget -O opencv.zip https://github.com/Itseez/opencv/archive/3.4.1.zip

    wget -O opencv_contrib.zip https://github.com/Itseez/opencv_contrib/archive/3.4.1.zip

    unzip opencv.zip

    unzip opencv_contrib.zip

    sudo apt-get install cmake

     cmake -D CMAKE_BUILD_TYPE=RELEASE \
     -D CMAKE_INSTALL_PREFIX=/usr/local \
     -D INSTALL_PYTHON_EXAMPLES=ON \
     -D OPENCV_EXTRA_MODULES_PATH=~/opencv_contrib-3.4.1/modules \
     -D ENABLE_PRECOMPILED_HEADERS=OFF \
     -D BUILD_EXAMPLES=ON ..

Now, open a new tab in the terminal (SHIFT+CTRL+T) and do the following:

    cd
    cd ..
    cd etc
    sudo nano dphys-swapfile

You will have to save the file using CTRL+O (this will write out the change to the file) and then hit enter. Now hit CTRL+X to exit the Nano Editor.

    sudo /etc/init.d/dphys-swapfile stop
    sudo /etc/init.d/dphys-swapfile start

This is done to allow us to compile the OpenCV code using all four cores of the Raspberry Pi... Now, back to the other tab.

Arduino Assembly

Raspberry Pi Assembly