Difference between revisions of "Flow Cell Lab Activity"
| Line 11: | Line 11: | ||
==Prep for 3d Printing== | ==Prep for 3d Printing== | ||
{|align="center" | {|align="center" | ||
| − | | | + | |[[File:Printer.PNG|200px|thumb|right|top|Select The Printer in Matter Control]] |
| + | ||[[File:Printer.PNG|200px|thumb|right|top|Select The Printer in Matter Control]] | ||
| + | ||[[File:Settings_Layers.PNG |200px|thumb|right|Matter Control Layer Settings]] | ||
|- | |- | ||
|4||5||6 | |4||5||6 | ||
| Line 20: | Line 22: | ||
| − | + | \ | |
| − | |||
[[File:Settings_Infill.PNG|200px|thumb|right|Matter Control Infill Settings]] | [[File:Settings_Infill.PNG|200px|thumb|right|Matter Control Infill Settings]] | ||
[[File:Settings_Raft.PNG |200px|thumb|right|Matter Control Raft Settings]] | [[File:Settings_Raft.PNG |200px|thumb|right|Matter Control Raft Settings]] | ||
Revision as of 20:34, 7 April 2016
Introduction to Flow Cells
The purpose of this experiment was to see if distinguishing a flow cells mixing area would change the flow through the system. In a regular T- or Y-flow cell there is a laminar flow, a flow in which the two sides do not mix, that can be manipulated to give a non-laminar flow through the system. Using ten different manipulation of a typical flow cell, a way of having a non-laminar flow was experimented. Blue and yellow dyed RO water was used to determine the laminar/non-laminar flow of the flow cells by way of parastaltic flow pumps. These flow cells were created using Tinkercad to make a virtual object, 3D printed, and casted with silicon. To attach the parastaltic pumps to the flow cell, an acrylic plastic was drilled and tapped at the precise measurements of the flow cell created. Each flow cell was used and it was determined which resulted in laminar flow and which resulted in non-laminar flow as shown below.
Producing The Virtual Object
Tinkercad.com
Sujith
Prep for 3d Printing
| 4 | 5 | 6 |
| 7 | 8 | 9 |
\
A gcode file is required in order to print an object on the 3D printer. This file can be created by exporting one's Tinkercad object as an STL. The STL file can be imported into Matter Control.
The gcode file contains settings specific to the 3D printer being used in production of the flow cell. As a result, one must ensure that the proper printer, material, and settings are chosen before exportation of the final gcode.
parameters
Chris
3d Printing
Silicon Casting
Flow Cell Construction
Flow Cell Experimentation
video/camera results