Reflection of Tungsten Bulb - Revision history

Jmccrery: /* Introduction */

2019-01-31T21:16:08Z

Introduction

2019-01-31T21:15:34Z

Results

2019-01-31T21:14:16Z

Results

2019-01-31T21:13:13Z

Results

2019-01-31T21:08:48Z

Introduction

2019-01-31T21:08:29Z

Experiment

2019-01-31T21:08:06Z

Results

2019-01-31T21:05:59Z

2019-01-31T20:59:19Z

2019-01-31T20:57:30Z

@@ Line 1: / Line 1: @@
 =Introduction=
-Light reflects off of surfaces differently depending on the surface.  It is known that different metals reflect light at different wavelengths and intensity, but wanting to know how tungsten light reflects off of two different surfaces was tested.  These being Aluminum foil and Silver Chloride.  Thus the metals that are being tested are Aluminum and Silver.
+Light reflects off of surfaces differently depending on the surface.  It is known that different metals reflect light at different wavelengths and intensity, but wanting to know how tungsten light reflects off of two different surfaces was tested.  These being Aluminum foil and Silver Chloride, thus the metals that are being tested are Aluminum and Silver.
 =Experiment=

@@ Line 6: / Line 6: @@
 =Results=
-It was shown that the aluminum foil reflected all of the light that the tungsten bulb put out as can be seen from the graph, there was no significant change from the diode being directly onto the tungsten bulb in relative to it reflecting off of the aluminum foil.  However, the silver chloride showed a difference in the spectrum from 460-600nm as the intensity was much lower in those areas.  We can assume this means that the silver chloride absorbed those wavelengths instead of reflecting them as the foil did.
+It was shown that the aluminum foil reflected all of the light that the tungsten bulb put out as can be seen from the graph, there was no significant change from the diode being directly onto the tungsten bulb in relative to it reflecting off of the aluminum foil.  However, the silver chloride showed a difference in the spectrum from 460-600nm as the intensity was much lower in those areas.  We can assume this means that the silver chloride absorbed those wavelengths instead of reflecting them as the foil did. It is also shown that the intensity being reflected from the aluminum chloride is much less than the rest other two trials, this shows that the aluminum chloride's reflective properties are not as strong.
 [[File:Light_Experiment.jpg|400px|thumb|left|Figure 1: The intensity and wavelengths of a tungsten bulb being reflected off of nothing, aluminum foil, and silver chloride. ]]

← Older revision		Revision as of 21:14, 31 January 2019
Line 6:		Line 6:

	=Results=		=Results=
		+	It was shown that the aluminum foil reflected all of the light that the tungsten bulb put out as can be seen from the graph, there was no significant change from the diode being directly onto the tungsten bulb in relative to it reflecting off of the aluminum foil. However, the silver chloride showed a difference in the spectrum from 460-600nm as the intensity was much lower in those areas. We can assume this means that the silver chloride absorbed those wavelengths instead of reflecting them as the foil did.
		+
	[[File:Light_Experiment.jpg\|400px\|thumb\|left\|Figure 1: The intensity and wavelengths of a tungsten bulb being reflected off of nothing, aluminum foil, and silver chloride. ]]		[[File:Light_Experiment.jpg\|400px\|thumb\|left\|Figure 1: The intensity and wavelengths of a tungsten bulb being reflected off of nothing, aluminum foil, and silver chloride. ]]
−
−	It was shown that the aluminum foil reflected all of the light that the tungsten bulb put out as can be seen from the graph, there was no significant change from the diode being directly onto the tungsten bulb in relative to it reflecting off of the aluminum foil. However, the silver chloride showed a difference in the spectrum from

← Older revision		Revision as of 21:13, 31 January 2019
Line 7:		Line 7:
	=Results=		=Results=
	[[File:Light_Experiment.jpg\|400px\|thumb\|left\|Figure 1: The intensity and wavelengths of a tungsten bulb being reflected off of nothing, aluminum foil, and silver chloride. ]]		[[File:Light_Experiment.jpg\|400px\|thumb\|left\|Figure 1: The intensity and wavelengths of a tungsten bulb being reflected off of nothing, aluminum foil, and silver chloride. ]]
		+
		+	It was shown that the aluminum foil reflected all of the light that the tungsten bulb put out as can be seen from the graph, there was no significant change from the diode being directly onto the tungsten bulb in relative to it reflecting off of the aluminum foil. However, the silver chloride showed a difference in the spectrum from

@@ Line 1: / Line 1: @@
 =Introduction=
-Light reflects off of surfaces differently depending on the surface.  It is known that different metals reflect light at different wavelengths and intensity, but wanting to know how tungsten ight reflects off of two different surfaces was tested.  These being Aluminum foil and Silver Chloride.  Thus the metals that are being tested are Aluminum and Silver.
+Light reflects off of surfaces differently depending on the surface.  It is known that different metals reflect light at different wavelengths and intensity, but wanting to know how tungsten light reflects off of two different surfaces was tested.  These being Aluminum foil and Silver Chloride.  Thus the metals that are being tested are Aluminum and Silver.
 =Experiment=
 Two different types of metals were used to test the reflecting and intensity of light from a tungsten bulb.  These metals were aluminum and silver.  This was experimented against a control of there being no reflection (the light was emitted directly onto the probe).  To test these a photodiode array was used and the data was then processed through Spectra Suite and Igor.

@@ Line 4: / Line 4: @@
 Two different types of metals were used to test the reflecting and intensity of light from a tungsten bulb.  These metals were aluminum and silver.  This was experimented against a control of there being no reflection (the light was emitted directly onto the probe).  To test these a photodiode array was used and the data was then processed through Spectra suite and Igor.
 =Results=
-[[File:Light_Experiment.jpg|400px]]
+[[File:Light_Experiment.jpg|400px|thumb|left|Figure 1: The intensity and wavelengths of a tungsten bulb being reflected off of nothing, aluminum foil, and silver chloride. ]]